- Isolation Booths (12)
Studio Acoustic Foam Treatment (130)
- - Acoustic Foam Panels (29)
- - Acoustic Foam Tiles (34)
- - Melamine Acoustic Foam (14)
- - Bass Traps (10)
- - Acoustic Ceiling Tiles (2)
- - Acoustic Floor Tiles (3)
- - Room Analysis (1)
- - Isolation Equipment (7)
- - Acoustic Tile Kits (16)
- - Bass Trap Kits (4)
- - Starter Kits (8)
- - Installation Tools (1)
- - Diffusors (1)
- Cinema & Listening Room Acoustics (25)
- Office Acoustics (46)
- Soundproofing Products (52)
Tecsound SY100 High Performance Soundproofing Mat 1.2m x 4m Self Adhesive
Dimensions - 1.2m by 4m and 5mm thick (nominal) 10kg/m2
TECSOUND® SY is a high density polymer-based, asphalt-free, synthetic soundproofing membrane, that offers good acoustic insulation in different building elements. It is equipped with a self-adhesive layer, to allow its direct application on the majority of building surfaces
High acoustic insulation, combined with soft, flexible elements.
Great elongation capacity
Easy handling and adaptable to uneven surfaces.
Good bonding to most of the types of surfaces.
Acts as a vapour control layer
Cold- and heat-resistance.
Excellent ageing resistance.
Soundproofing against airborne noise in vertical walls with low surface density (lightweight partition walls or boards made of different materials).
Soundproofing against airborne noise in ceilings and lightweight roofs.
Reduction of impact noise level in all types of floors, sandwiched between floor slabs and loose-laid flooring.
Damping of impact noise caused by atmospheric agents on metal decks.
Combined with sound-absorbent materials, it offers products with high acoustic performance.
Its applications in the industrial field cover from the soundproofing of booths to the acoustic insulation of machine-rooms, gutter pipes, sound damping of metal sheets, etc.
Substrate: TECSOUND SY lends itself to all types of normal building substrates (renderings, gypsum board, metal, DM, plastic materials). The substrate must be even, smooth, clean and dry. It must also be free from elements that could damage the membrane. If the rendering is old, its condition must be checked to avoid adherence problems of the TECSOUND sheet to the rendering. Installation of the membrane: Remove the protective silicone release paper, and align the membrane on the substrate, exerting pressure over the whole membrane to ensure good bonding. If the length of product is very large, or it is applied in rolls, remove the protective release paper progressively to aid installation.
Installation of the membrane on metal decks: The membrane must be applied in such a way that the length of the roll is perpendicular to the direction of the fretwork. The membrane must be made to follow the profile of the metal support at all times, ensuring that there is no formation of air pockets. The thermal insulation boards are then installed, mechanically fastened.
Laps: Overlap 5 cm both vertically and horizontally. Care must be taken to always seal the laps correctly, as small openings can reduce the level of acoustic insulation required.
Yield: 1 m2 of membrane covers approximately 0.95 m2 of surface area, including overlaps.
REGULATIONS · In accordance with the following norms: CTE-DB-HR, EN ISO 140-1, EN ISO 140-3, EN ISO 140-6, EN ISO 140-8, EN 20140-2 and EN ISO 717/1/2. · Quality System in accordance with ISO:9001
≥ 150 x150
≥ 200 x 200 %
Vapour Water Resistant Factor
μ ≥ 4.15·104
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: